The I2C operation mode is I2C_OPER_MODE_POLLING, and SENSOR_I2C_TIMEOUT is 5000. When the camera's I2C communication is abnormal, it can sometimes cause the MCU2_0 OS to block for about 18 seconds.

Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

When I read the values in the Registers Table in BQStudio for my battery assembly I see a voltage value of 7656 mV and individual cell voltage of 3830 mV (Cell 1), 3827 mV (Cell 2) and 3834 mV (Cell 3 ...

I would like to know on the use of TPS6594-Q1 with AM5716AABCXEA. Currently we are using TPS659162RGZR. Is TPS659162RGZR being discontinued? Are there any issues with using the AM5716AABCXEA?

I'm developing support for custom flash device "MX25L12833FM2I-10G". I'm having troubles using the flash in 1S-1S-4S. I managed to configure correctly the flash in the 1S-1S-4S protocol. After ...

Please try the steps below to debug this exception . 1. Keep break point in the Master's ISR 2. Note down the R14 Register 3. Search for the R14 register address in the Map file. Here, the address ...

I am using the TLV5636 12-bit DAC. I have noticed by single stepping through the debugger that the first DAC register write immediately following a Reference Select control register write is IGNORED.

Recently, I have updated my board to SDK 10.00.00.08, and I have updated my Docker container accordingly from edgeai-tidl-tools I can compile and run ResNet-18 and MobileNetV2 on my TDA4 board without ...

I am using TPS546D24A in my design & below are the details. 1. I would like to calculate the power dissipation of this device. Is there any tool/excel available to calculate the Power dissipation of ...

Texas Instruments (TI) Logic support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search logic IC content or ask ...

I am using CCS version 11 and I would like to use SVN. I tried installing Subversive 4.0.5 from the Eclipse Marketplace, but the SVN Connector did not install properly and it didn't work. I also tried ...

Our final code is built from several projects one of which is specific to the product. The others are general projects which are designed to run on any product. Each is built into an abs file, and the ...