The I2C operation mode is I2C_OPER_MODE_POLLING, and SENSOR_I2C_TIMEOUT is 5000. When the camera's I2C communication is abnormal, it can sometimes cause the MCU2_0 OS to block for about 18 seconds.

Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

If a place a Voltage Generator on a new schematic and then attempt to change the signal type (from the default Unit step) to any other type (e.g. sine wave) then Tina TI freezes and is unresponsive.

Texas Instruments (TI) Logic support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search logic IC content or ask ...

When I read the values in the Registers Table in BQStudio for my battery assembly I see a voltage value of 7656 mV and individual cell voltage of 3830 mV (Cell 1), 3827 mV (Cell 2) and 3834 mV (Cell 3 ...

I'm developing support for custom flash device "MX25L12833FM2I-10G". I'm having troubles using the flash in 1S-1S-4S. I managed to configure correctly the flash in the 1S-1S-4S protocol. After ...

I have made a custom PCB using MSP430-FR6047 to measure flow. I wanted to know if it was possible to initialise flow parameters (Parameters under configuration tab in USS Design center) directly ...

Please try the steps below to debug this exception . 1. Keep break point in the Master's ISR 2. Note down the R14 Register 3. Search for the R14 register address in the Map file. Here, the address ...

I am making Phase shift full bridge converter by using TMS320F280039C. I am running the voltage controller in CLA as below. Voltage controller execution time is 3us. So running CLA at 300kHz. I want ...

I am using CC2340R5-Q1 and i have merged SPI driver in Basic_BLE code. I am trying to communicate with NTM88 TPMS IC to get the Tire Temperature and Pressure readings. CC2340R5-Q1 is acting as SPI ...

I was failed to rebuild and download the Lab01 of UCD3138 on CCS. When I downloaded the original .x0 file to UCD3138CC64EVM-030, I can see the string contents through the memory debugger of UCD3138 ...

I am running a tcp server using the enet_lwip example provided for the F28388D board. I am using a sample application code for TCP Server, this code is tcpechoserver. This code works fine, it reflects ...